This website is not sanctioned or approved by any manufacturer or tradename listed. Designated trademarks, brand names and brands appearing herein are the property of their respective owners. Products sold by come with ’s 1-year, 2-year, or 3-year warranty and do not come with the original manufacturer’s warranty. is not an authorized distributor, affiliate, or representative for the brands we carry. Has anyone had this issue before and found a way to have Studio5000 keep the original octet scheme? I don't see this normally being an issue, but the customer has specifically asked that the I/O tag names be kept the same as the original program. I hope this make sense, but basically the first seven tags match between the projects, but then I:010 in rslogix 5 is equivalent to I in 5000, I:011 is I, and so on and so forth. ) from the RSlogix 5 program, are switched into a sequential scheme in Studio5000 that just increments them in order (1, 2, 3, 4. My problem is that once I convert the program, my I/O tags that were originally sequenced in octets(0-7, 10-17, 20-27. I referenced the manual (I'll attach link below), and had no issues using the RSlogix Project Migrator tool that I downloaded off the Rockwell website. I've recently been tasked with converting a RSlogix 5 program from an old PLC 5 project into a Studio5000 project. Working in Automation for the first time as a Co-op student so i'm fairly new to PLC's and the Automation field in general.
